FS2 Rear hub mistake
 

Hello all
I made a mistake and bought the .5 degree rear alloy hubs for my car and it now has too much toe in. I cant send them back now as i have used them so my question is can i take the toe angle away a bit by changing the law 36 and law 37 and how will this affect the car.

Simple answer is yes, change the insert in the RR holder to be one leter back (so if you normally run an E out like I do you would use a D out instead).

Whilst I doubt most people would notice it too much your car will feel a little more stable in rusty sections & a little more prone to rear end rotation early in a corner / off power.


I will have run 1 deg hubs with 2 step reduction in in board toe (done the correct way, RF 1 step wider, RR 1 step narrower) on blown out / torn up grass tracks to help the car see through bumpy straights)

Thanks roger