Orca 6.5 rough noise?
 

Hi guys,

My motor was sounding sweet until when I was racing on astro it started sounding rough. So I stripped it down and gave it a quick clean but still sounding bad. Any suggestions?

Thanks,
Sam

Take it apart and make sure the black magnet part is properly attached to the shaft. Mine came un glued and acted like a slipper for a few meetings, then gave up and span internally!.

Same brand and turn too :cry:

Just oiled bearings and still no difference, still glued but the front plate and bearing are jammed on the shaft????? :cry: I think I might just buy a new motor and give that to leggie to look at...