LRP SXX V2
 

Hi,iv got my LRP back from repair,it wont let me calibrate it to the handset,i get 3 flashing lights,when i hold down the set button to go into calibrate nothing happens,
when i do the same thing on my old 2007 sphere,in the same car,it will let me do it as and when i want,
any ideas
thanks

Have a look in the manual for error codes as you may have a faulty sensor wire, low Voltage, etc?

Sorry to state the obvious but check that the receiver wire is plugged in the receiver properly. It will do what you say if it isn't

thanks chaps,iv had a look and its plugged in ok,
i had a look at error codes,it does show the error you say,but im doing it on a brushed setup,
if i plug it into a 1s battery it will show the blue light an a green,this is before i press anything,

You can't use the ESC on a brushed motor so it is probably showing a short.

LRP SXX V2 BRUSHLESS
 

Take a look at the Manual LRP SXX V2 Manual(PDF)

Pure "BRUSHLESS" won't work with brushed motor :blush:

The LRP Sphere will support brushed motors but NOT the SXX

:woot:

i have a novak gtb mark that will work with brushed, i would be willing to swap or sell

Its fine thanks,its for my buggy,i was just testing it in my ss and that had a silvercan in

fair enough, you need to come down to a1 again mark

Thanks for all the help chaps,fitted a brushless motor and its all good :woot: