my pred
 

well nearly done on the pred, all working and running smoothly, need to order a new shell ,took some pics

Looks nice darryl. Clean it and it will look even better :) haha.

ben

hope u go well with it :thumbsup:

you have some cheek ben the only reason your car is so clean is you have to replace all the broken bits every week ha ha:p

i got the 501x to go well im sure the pred will do just as good mate

Well i wasnt gonna lie was i. haha

ithought it was looking clean ???, anyway using brushed system at mo just for initial testing before i put gtb in, (theres not alot of room to play with)

when u put ur gtb in u have to build a platform off ur servo and place the esc in the middle over the centre shaft

i had alook on the pred website and someone has posted pics and put the speedo down where reciever is and put reciever on top of servo, thanks for advice shane

not sure the gtb will go in that way

ive just looked on pred forum and the servo been used is not a starndard sized servo

will find out when i try:confused:, but for now will stick to cyclone and checkpoint

here is a pic of my x11 with a gtb, also have a low profile futaba s9551 servo, futaba fasst reciever.. not easy by all means.

thanks jeff your pictures will help when installing mine
thanks very much
darryl

Looks very nice Darrl, i run checkpoint in my X11 and they dont hang about ! :lol:

Which wind are you using ?

im running a 10x2, not sure on gearing as yet but have stuck a 19 tooth on

Thats what i was running a 10x2 and its mental fast indoor. Gearing wise i would go 18 indoor at york.

Are you racing at South Sheilds Regional next week mate?

cheers garry will drop a tooth and see how that goes
thanks

I would also reccomend a little fan aswell to go near youre motor near the endbell.

all depends if you throttle jam or not;), will keep an eye on temp of motor after first run at york, then if i need one ill get one:thumbsup: