xx4 motor plate
 

Im after a xx4 motor plate that is the same profile as the original xx4 one so it sits fluch with the end of the motor clamp but allows the motor to sit as low as the worlds edition one. I have an original xx4 one and a WE one but if i use the original one the motorfouls on the bodyshell and if i use the we one it foals on the chassis.

A

Dremel + chassis = bigger hole for motor to sit into ;):thumbsup:

I run the std one, doesn't rub on the ground or body.

You need to drill some new holes in the standard xx4 one Ash, had the same problem on my old X5.

Ok i was thinking about that as a possability thanks craig.

A