oOple.com Forums - Fitting a Sintered Rotor

oOple.com Forums (http://www.oople.com/forums/index.php)

- Electrics (http://www.oople.com/forums/forumdisplay.php?f=26)

- - Fitting a Sintered Rotor (http://www.oople.com/forums/showthread.php?t=10818)

Kecky

14-05-2008 09:34 PM

Fitting a Sintered Rotor

I'm swapping the bonded rotor in my LRP Vector X11 5.5, for a sintered rotor part no.50610

Is it just a case of undoing the 3 screws, pulling the old one out, carefully putting the new one in without it picking up any debris, and putting the 3 screws back in.

josh_smaxx

14-05-2008 09:35 PM

Pretty much, just take note of all the shims and make make sure they go back in the same way they came out.

Chris Doughty

14-05-2008 09:58 PM

you pretty much have it spot on.

be careful when you get the rotors out of the packet, they have a tendancy to jump out of your hands to clunk against something metal, the magnetic power they have is immense!

Kecky

14-05-2008 10:20 PM

Thanks a lot guy's, it's nice to be reassured :D

All times are GMT. The time now is 07:48 PM.