hpi flux pro / hobbywing v3 speedo setup help
 

hi i have just bought a hpi flux pro v3 speed controller and i am planning to run it in a 2wd buggy so could anyone give me a good starting setup i no they is a buggy/shortcourse mode but has any one got any idears.
also could somebody explain how this 2 stage punch and 2 stage brake works

Hi there gaz when I get home later I will pm you the teams starting point for the Speedo.
Nathan Ralls

Any chance I can get the Speedo setup too
Thanks

Me too!!
Have been using it on my 4wd with a 7.5 / 6.5 Novak with the buggy profile and my V2.1 is better (smoother and faster)!
I am thinking of putting the turbo off and go to 20 to 26 points for boost/timing, possibly upping the end rpm?!
Thanks.

fun that mate i have run my hobbywing v2.1 and hpi flux pro v3 back to back same motor and like you say the v2.1 seems faster and smooth than the v3.
could be that the v3 is still in beta form firmware?
plus i have been told not to run above 80% brakes as you get brake fade through the run

so has anyone got a good setup for a 2wd?

just sent nathan rails a pm about that setup for the v3 speedo hopefully he should get back to me shortly