db-01/502X front Hex
 

Anyone know where I can get some, I lost mine in the grass today.... and I think it got sucked into a parallel universe and vanished.

Brockmodels have them

top man!!

Budgio, you got a PM

Guys, Brock models, not being funny, their site is unsecure.

Any losi type hexes will fit if you drill them out. I run hot bodies XX4 hexes and will soon be running AE B44 hexes (again drilled out)

I was looking at the B44 ones, and am tempted by them, as I could run the B44 front wheels then!!

But I run Tamiya wheels on my B44, or is it late and I'm too tired to get what you're saying?!!

Has anyone run B44 front wheels with the normal, factory 501X front wheel hex? Do they fit ok? A friend gave me a set but I have not mounted tires to them.

the B44 wheels have a deeper hex, so when you tighten down the nut, they bind grr

Sorry if I'm asking an obvious question, but how should I go about drilling some AE hexes? I need to increase the internal diameter from 4.7mm to 5.0mm to fit the DB01R axles. Is it just a case of holding it in a vice and using a regular 5mm bit?

just fit the imperial drive pins with a bit of AW grease I would of thought.