Losi Shock Lengths
 

Hi everyone, I need a small favour.
Could ash or someone please measure up some losi shocks body lengths?

I need a 0.6" (XX4 and XXX-CR Front), 0.9" (XXX-CR Rear) and 1.2" (XX4 Rear).

I need the measurement to include the outside edge of the shock cartridge screwed in, and to the dead centre of the hole where it mounts to the shock tower please.

Thanks
Mark

give me 5 minutes im off with my ruler.

A

Right as acurate as me and my steel rule can be. From the bottom of the shock body not including the cartridge to the center of the mounting hole is:

XX4 rear: 5cm
CR rear: 4.5cm
xx4/cr fronts: 3.8cm

Hope ive heped.

A

Sorry mark miss read your post ill go measure with the cartradiges in.

A

Basically a cartridge is 3.5mm so add 3.5mm to the above measurements.

A

Are you sure ash:confused:

The bit of the cartridge that shows is 3.5mm

A

he means remove not add imo

No, Ash is right! I wanted to include in the length the cartridge that protrudes from the body.

Thanks Ash!
Mark

How long is the threaded part of the cartridge?

I am trying to see if some Threaded Losi shocks will fit my Cat 2000 EC, as I am already running Losi Shafts!

Thanks
Mark