oOple.com Forums

oOple.com Forums (http://www.oople.com/forums/index.php)
-   Schumacher (http://www.oople.com/forums/forumdisplay.php?f=46)
-   -   SV2 Diff rebuild problem (http://www.oople.com/forums/showthread.php?t=105156)

Skelbo 08-07-2012 12:10 AM

SV2 Diff rebuild problem
 
Guys. I'm looking for some help. I have rebuilt my SV2 diff but I am not getting any diff effect at all once built.

I am using all new parts except the male/female out drives, the gear itself and the 2 bearings. The rest is new - washers, screws, thrust and t/c balls.

I tighten it all as normal and back it off 90 degs. It is so tight that I can not move it at all. If I back it off an extra 45 or 90 degs I can finally get it to move (just) but it is still very tight and only one side of the diff will move. Zero diff effect. If I hold both sides I can just about get the gear to slip.

I have taken it apart and rebuilt again 3 times, with the same result. No matter how much I tighten or loosen there is no diff effect.

I am clearly getting something wrong, but when I built the kit originally it went together fine. Same instructions, same me! So what am I doing wrong?

gaz1318 08-07-2012 03:16 AM

have you got both spacers in

Cruise 08-07-2012 05:20 AM

gear is directional.Look for the slight raised bearing fit .This has to go on the male side.

Cruise

Skelbo 08-07-2012 05:43 AM

Spacers, yes. Directional gear is a very good shout, thanks. That sounds like it could be the answer. Will report back later.

Skelbo 08-07-2012 07:27 AM

Thanks Cruise. Problem solved.


All times are GMT. The time now is 01:53 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
oOple.com