offical brca width of 1/10th buggy
 

just trying to find out as I have been told the b44.1s dont fit the box?

23.3 The dimensions must conform to the following:-
Maximum length - 460mm inc. bumpers
Maximum width - 250mm at any point of suspension travel in a vertical plane.
Minimum weight - 1474grams for 2WD, 1588grams for 4WD complete and ready to race. The minimum weight(s) include fixed Personal Transponder but exclude Auto-powered (hand-out) Transponder.

You've been told wrong, buddy!

Mine fits:thumbsup: I haven't had to do anything to alter it either.

I seem to remember I did have to grind a tiny bit off the front wheel axles on my B44 though. But the B44.1 seems fine

okay just checking as I am going to attempt my first regional since getting back into it last year should give me an idea how good or bad I am doing:lol:

It can very much depend on the car setup (toe out, camber, wheel base/width) and the tyres used (e.g. mini pins are wider the mini spikes).

I have seen large variations on the same model cars for just this. Some rattle some won't even go in.

Don't forget that it is over the full suspension travel. Some cars get wider at their mid travel point.

James