hobbywing problem
 

can anyone help please i have a new hobbywing ezrun 60a esc and after i use the brake it wont go to full throttle gets slower then stops and flashes red wont then work until turned off then on again i have tryed changeing reciever but does the same thanks for any help.

Have you checked the settings and wiring?

HW trouble
 

Best thing to do is the very un-manly thing of reading the instructions and setting it up to your transmitter. Just make sure your transmitter neutrals are set to neutral. Rates set to 100% etc.

yes i have done everything i can think of

HW
 

What radio gear are you using ? With what motor ? Cells Etc. Might give other people a shot at getting it right for you.

Hi
green flashing meens thermal overheat
red flashing means low voltage
if battery not flat
check the voltage cutoff setting
and battery connections

Possible success i HOPE i tryed another battery it was the same so i tryed moveing the lipo cutoff from the max of 3.4v to 3.0v and it seems to be ok i ran it up and down the road for 4/5 mins with no probs could this be it ? ANY COMMENTS thanks paul ps thanks dombrasky for hopefully pointing me in the right direction

Glad you got it sorted
it needs to be 3.0 per volt anyway as the current draw especially
when flat out can dip below 6.8 volt
:)