oOple.com Forums

oOple.com Forums (http://www.oople.com/forums/index.php)
-   1/10th OFF ROAD (http://www.oople.com/forums/forumdisplay.php?f=161)
-   -   Car runs slowly forwards (http://www.oople.com/forums/showthread.php?t=101333)

matthewboyles 17-05-2012 06:18 PM

Car runs slowly forwards
 
Hi!
My RC electric car has started running slowly forwards! It runs faster backwards. I have two fully charged batteries and they both do the same thing. Now I think about it, it has been accelerating a little slowly uphill/offroad for a few days. Any advice? Do I need a new motor or can I rebuild it? Its a brushed motor.
Thanks!

Chequered Flag Racing 17-05-2012 06:21 PM

would help if you posted what electronics, motor, transmitter etc you are using to get some meaning full advice :thumbsup:

matthewboyles 18-05-2012 12:35 PM

Hi, my transmitter is a digital radio control system NO:H734071. My motor is a brushed 540 one. My receiver has no sticker on it! What other info might you need? Its odd how this just started happening a few days ago. It was fine before!
Thanks a lot

Brewskie 18-05-2012 12:49 PM

Have changed any wires or anything around, motor could be running in reverse as when u go to go forward u are but with the reverse being forward if u know what I mean lol

matthewboyles 18-05-2012 01:10 PM

Hi, It still works in the right direction, its just that it does not go very fast forwards! If its going down hill it does get speed up, but back up the hill it slows down again, like its not got enough 'torque' to go fast.
Thanks again!

mark christopher 18-05-2012 01:44 PM

does your radio have end point adjustments? can you post a picture or link of your transmitter?

matthewboyles 18-05-2012 02:05 PM

Yes it has three adjusters, one adjusts the steering left to right (ST Trim) set to 0, one seems to set it running backwards or forwards slowly if on anything other than 0 (TH Trim) and a third one is ST D/R which adjusts the range of the steering left to right, set to 5 out of 6.
Thanks!

Col 18-05-2012 03:21 PM

What car is it?
It sounds like a ready to run "cheap" one (no offence intended!)

rondoolaa 18-05-2012 04:48 PM

have you tried swapping the motor wires around and at the same time reversed the throttle channel so it still goes the right way, this would tell you whether it is a problem inside the transmitter pot

matthewboyles 18-05-2012 07:29 PM

Thanks illtry that...its a cheetah

jkclifford 18-05-2012 08:15 PM

brushes in the motor could be sticking, the brush starts to wear and wrap round the com, arcing when going forwards but won't when revesed.

Try filing the sharp edges off the brushes. Or fit new ones.

Chequered Flag Racing 18-05-2012 08:29 PM

Quote:

Originally Posted by matthewboyles (Post 656198)
.its a cheetah

like this?
http://www.hobbytron.com/Cheetah1-10...adRCBuggy.html

cutting42 18-05-2012 11:09 PM

On my sons radio, the direction you push the trigger when you first switch on defines itself as forwards so if you accidentally push the throttle backwards first, it reverses the direction and reverse is much slower than forwards so we sometimes see what you have seen

Hpi_guy 19-05-2012 06:55 AM

I had the same issue with my rtr blitz, the motor is dead, if it is a sealed 540 motor bust bet is to ditch the esc and motor and go brushless :thumbsup:

matthewboyles 21-05-2012 06:35 PM

Yes my RC loks a bit like that link. Different controller though. Think I need a new motor and esc!. Which brushless motor would you recommend for someone on a budget, please?

zoaman 21-05-2012 08:48 PM

sounds like your a little new to the electric side of things so would prob think you would be better of with a brushless combo.usually plenty for sale on the for sale section or on the auction site.remember if paying via paypal dont use gift.

BeachBuggyPhil 21-05-2012 09:09 PM

I had this same issue with my B4 and Novak GTB.
I reset the ESC and controller and it appears fixed.
I could go faster in reverse than I could forwards and on a 5.5t motor that's really fast backwards!
On another controller I have if I press the controller backwards before I press forwards it automatically sets its self backwards. I have to make sure I always press forwards first.

Danny Harrison 21-05-2012 10:57 PM

Quote:

Originally Posted by matthewboyles (Post 657137)
Yes my RC loks a bit like that link. Different controller though. Think I need a new motor and esc!. Which brushless motor would you recommend for someone on a budget, please?

http://www.ebay.co.uk/itm/Etronix-Ph...#ht_1735wt_952

These are good if your on a budget. Fairly programmable too.

Naushad 21-05-2012 11:02 PM

Instead of jumping the gun and shelling out on a new brushless system...get it looked at!

Pointless asking loads of questions when we have no pics/videos etc. It may be something fairly straightforward.

So, try to pop into your local model shop or club and someone could have a look at it.


All times are GMT. The time now is 02:46 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
oOple.com