Setup sheet question?
 

in this setup sheet adam wrote his pistons where 1.3 by 6 drilled, drilled to wat?

http://www.team-durango.com/pdf/setu...26_03_2012.pdf

Each piston has 6 holes of 1.3mm

Those are the pistons you have to use in the front according to the manual, it also says it on the piston itself: TD1.3x6mm.
I used them in the front and rear, because the rear was a bit stiff for my track

do they come blank or what in the dex408 because i no u can get the 1.3 by 6 hole but his says drilled i thought he drilled those pistons bigger or something

post in error

What car are you actually talking about? But if you want to know which pistons come with the 408 just check the manual on their website

There is a different behavior between a drilled and molded piston hole...A drilled hole will offer slightly more pack.

Start with a smaller hole sized piston then open it up to the required size with yes you guessed it a drill ;)

i run a dnx408 but was just looking at shock setups for dex408