Ok thanks Noel I will PM you at the end of the week I am waiting on other to split the shipping charges.

Den.

CREAM WEIGHT
 

Got my cream weight today, quality item, good machining, thanks for the speedy shipping. Same applies to the rear Camber mod:thumbsup:

Cream parts well-arrived in france today !
excellent job !
Hope to try them quickly on my 22 !

Thanks a lot Noel !:lol::lol::lol::lol:

Don't forget if you have the losi rear weight on, Try removing it. Thank's for letting me know it has arrived.

do you ship to the states?? and if so how much would it be??


MAtt

Hi Matt,
Yes I do ship to the states, it is expencive though at £8.95 for signed for delivery.
I've had a few in the past split the cost with other club members wanting other parts.

Cheers
Noel

i am not familiar with the conversion from euro to us dollar, how do i order ...i am thinking the wt. and the camber link

thanks..
matt

Cheeky bump for this very popular mod.
;)

Currenty this item is out of stock, I'll post again when I've produced some more.
Regards
Noel Grundy

Would it be possible to make the mount longer so it could also attach to the chassis in the outside holes on the chassis (mid motor setup of course)?

I find it very difficult to change toein or antisquat and get all the parts lined up to reinstall. If the piece was fastened to the chassis with the outside holes it would make installation of the arms and toein block so much easier

I have considered drilling a hole in the stock piece between the existing holes and a corresponding hole in the chassis so it's fastened the same as the toein block with the smaller screw

Back in stock.....


Bob_Zahn there are other issues if I make them bigger to include the to outer holes for screwing, Currently the original shims can be used, If I made them to include the outer holes I'd need to produce shims as well, which would add greatly to the cost as the are all different thicknesses.

If people use the original shims on a redesigned wider weight they would either have screws coming loose or chassis bending.

will be ordering mine finaly :)

You have PM,

Cheers
Noel

Have sent you a PM Cream, to buy two.

sent you a pm.

Felipe.

Is this a new one Ie a mk2 ?

No this is as the original post, There is no MK2. There are cost/design issues with producing a weight that uses the outer holes in the chassis.

Hi, I have PM'ed you about getting one of these weights. Thanks...

Got my order today, thanks.

Got mine ready to run,

Unfortunately weather is not giving a rest to try.