WELL!!! i never thought i'd see the day.......JC having a std car:woot:

Here is mine all ready to race mid engine with tekin pro, futaba 2.4 and small lipo. All on chassis, nothing on rear motor plate :thumbsup:
Attachment 21704

Attachment 21705

Nice install fella :thumbsup:

cheers buddy, this is the layout that Darren Bloomfield is running:lol:

I think it the picture! the back were pretty much in line ( I think! )

B4 wheel base = 273mm

22 wheel base = 285.5 mm

12.5 mm diffrent...

A

Well there are some little mods on there, I managed to get one bit of cf on there lol, but new proto cf parts should be on for it's 1st run next weekend ;)

hahaha, didnt think it would be long. Nice one:thumbsup:

Good work!

It certainly requires some creativity with the wiring. After lots of messing mine is presentable but my castle speedo means can't fit everything on the chassis. Gonna try routing motor wires back under the guard as you have as not sure my shell will fit as is.

Car built and electrics installed just waiting for a shell now.

I still think it was one of the easier installs to get neat.

I think the Losi LiPo is the best way to go, it looks to leave room at the side :thumbsup:

Just copy my install why don't you! ;)
much neater though with the 'minibrick' lipo in.

Shell is on the way dude. :)

wow was waiting for this thread to happen... some really nice wire work there dudes.....
those big bore shockers look awesome.....

oldtimer's install wins for me...:thumbsup:

How are my 1400mah nicads gonna fit in?


LOL

Dude... Yellow wheels! get some white stickers on them at least :p

Got mine today, going to start the build ASAP.

It aint your 1400 mAh nicads that will be your problem - it'll be your resistor speed controller with its 2nd servo and your 4-cell Rx pack :woot::woot:

But I'm sure you'll find a way JB

nice and tidy old timer.

here is how i have got the electrics in, plenty of room for me :p

http://img38.imageshack.us/img38/5418/dsc02296z.th.jpg
http://img232.imageshack.us/img232/857/dsc02295g.th.jpg
http://img146.imageshack.us/img146/4...c02294z.th.jpg
http://img171.imageshack.us/img171/8...02297tz.th.jpg

Lots of room when you put the electronics where Losi intended :)

Easy to swop to running saddles or the new small lipo as I don't have a load of electronics shoe-horned into the front. Could also run a normal stick lipo (there's room with a low profile servo) if I popped the receiver on top of the lipo.

Just need Jonathan to bring out a nice carbon battery bar instead of the straps :)

http://www.andrewshillito.com/oople/losi22_1.jpg
http://www.andrewshillito.com/oople/losi22_2.jpg

Ran it like this indoors, with no cooling cut out's in the shell and it barely got warm, so can't see heat being a problem at all.