i will try mate:)

Phil, was not aware you had sent the speedo away to them (Tekin), I hope they have sorted it out for you, last I knew you were emailing their tech department for advice.

Must of been somthing wrong with the original for them to have swapped it, assuming it isnt the same one refurbed they have sent you back that is. Let us know if there are any further problems.....

I have software version 180 in my RS Pro and am looking to install this into a CAT SX running Lipo and going to a 6.5 SpeedPassion motor. Gearing will be around 23/83 giving a FDR of 9.32. Does anyone have more Hotwire setting suggestions for this sort of setup?

9.32 might be a little steep, try it on a 22 initialy.

Timing set to 80
Limiter to 95
TP3
Neutral 10

Thats a good starting point, but if you got Hotwire, let the hotwire update your software!

I have seen setup sheets where they are using that gear ratio on a 5.5. I tried a 21 on a 5.5 and it was insane especially when using LiPo so I am currently running an 18 which is much more controlable. I have the Hotwire so I am looking forward to when Tekin release the newer firmware which from what I read will be 183 or maybe 189.

The Tekin RS Pro is a gr8 bit of kit.

Ive changed the settings to the highest punch setting and all seems fine and dandy in 4wd buggies. I have had a couple of glitches where the esc needs reprogramming as its for some daft reason its forgotten whats what but the esc works fine.

No over heating which is good.

Its also a heck of a lot smoother and better to drive than the sensorless esc's (i have two mamba max esc and they are not as good) and the motors seem much more manageable compared to the sensorless. I also found that the Tekin work really well with Corally compared to anything else. No idea why.

If your want a speedy reply email Jim at Tekin, he is pretty quick at sending a response relating to anything.

what is the "punch setting" ?
i am french i run with trf501x, vortex 6.5 and 19/96= 10.3 ratio
and i have not a good punch .
i have 80% timing , linear trottle profile.
with this configuration i have a low punch why?
thanks seb

You must have software version 189 or higher to have timing boost for spec motors. The team has been testing version 194 which is now available from Randy, [email protected]

Tekin Prez
Jim Campbell