Yes ran it once, it ran fine the motor was hardly warm at all.

I have a fan for this ESC if required but I ran it like this in my old B44 with the same motor and no problems.

D Boots Multibytes in A (medium) compound, supposed to be pretty good for the astro

Heres my V3

http://i30.photobucket.com/albums/c3...a/IMAG0654.jpg

With the CF protector that actually holds up really well

http://i30.photobucket.com/albums/c3...a/IMAG0650.jpg

wer do u get the protector?

ebay can't remember the seller but there are lots there

Hi, is possible to say were to by? is specified for dex or is need cut the CF ?

Just look you have to cut it out and do all ther screw holes yourself, its not too hard
Here

My Pair of Rangos
 

Finally got my Finnisher shell for my 210. Looks great (apart from my paintwork!)
410 has Team Azarashi Fettera which i think is still the smartest shell for that car.

Dave

very nice Dave. :thumbsup: I'm holding out for the proline shells. You going down to this west coast place tomorrow ?

Na, gonna go to Falkirk. If it's on? You goin down?

smart dave, you racing both classes at batley pal.

Yeah bryan and i are going down. Not sure if falkirk is on, i was under the impression most were going down to westcoast, might be wrong though.

That is stunning! :woot::woot: where did you get the paintwork done?

410
 

My 410
http://img692.imageshack.us/img692/7...1056959506.jpg
http://img718.imageshack.us/img718/7...1057035264.jpg
http://img854.imageshack.us/img854/5...1057108460.jpg
http://img268.imageshack.us/img268/8...1057220829.jpg

Very nice! Loving the black and orange look.:thumbsup:
Where did you get all the bling and screw kit?

Any pics of yours Andy? :)

410
 

Kit screw is 2 x kit screw titanium trf 201 ;)

I've now got carbon fibre effect chassis protectors with all the holes pre-cut available here....

http://www.oople.com/forums/showthread.php?t=95202

http://i948.photobucket.com/albums/a...e/IMG_7990.jpg

Love the foam inserts where did you get those?
Oli

I lost the hope in durango part support so i brought some hpi ball stud's and rpm ball cups. Mounted some short rpm cups because the long ones are still underway from the US of A

And a new motor! TenShock 4 pole :drool:

you need 3 bags (a total of 12 ball studs) for a complete make over
http://i25.photobucket.com/albums/c8...r/IMG_0772.jpg

The old ones
http://i25.photobucket.com/albums/c8...r/IMG_0777.jpg

New ones
http://i25.photobucket.com/albums/c8...r/IMG_0775.jpg

make sure you buy the rpm long cups, these are a bit to short
http://i25.photobucket.com/albums/c8...r/IMG_0770.jpg


http://i25.photobucket.com/albums/c8...r/IMG_0787.jpg
http://i25.photobucket.com/albums/c8...r/IMG_0782.jpg
http://i25.photobucket.com/albums/c8...r/IMG_0784.jpg


And a new motor :wub

http://i25.photobucket.com/albums/c8...r/IMG_0793.jpg