511/503 Front 12mm hexe
 

Could somebody tell me what make and model these front hexes are and also where I might purchase them from. I'm looking to add 12mm hexes on the front of my 511 and wanted to keen a similar track width. Thanks

http://i202.photobucket.com/albums/a...psd1f4c936.jpg

The 12mm front hexes are made by either RC Square or Active hobby and they are for any Tamiya Drift Chassis.... These can be purchased in Japan or in Hong Kong.
http://www.rcmart.com/active-hobby-s...l?cPath=35_780

Is there a grab screw on this hex's ?

No grub screw... the fit on similar to the stock front Tamiya hex..:D

I Use the 4mm thick 12mm hexes for Tamiya touring cars.
Just dremel or file the thin lip, takes about one min and you have 12mm clamping front hexes :)

Any new parts out there that will give more protection to the diff's?

What type of protection..? Belt or internal to the diff??:confused:

Tried that a while back and I had issues with the wheel nut not holding to well... might have been the nut I was using though:blush::eh?:

I know. there is less thread left than with your solution.
I use the Hobbyking serrated nuts, and no dnf`s yet

I mean covering some parts of the belts and diff's

Thanks Dave, just managed to pick up a set from RC Mart. Cheers, Oz

:thumbsup: You got the last set...... Tamiya is also making a 12mm front hex soon so we should be able to get our hands on them in a month or so:woot:

I got the last set lol

I still make diff covers and chassi protectors for 503.
Fredrik [@]t-star.se

Your still alive :woot::p:thumbsup:

The cover i purchased from you a wile ago did break in two pieces after few runs with the car.:(

Rcmart just email me saying that they canceled the order because they realize that STR154DB are out of stock.
Any alternative hex from rcmart?

Let me see if there is a place that has the RC Square ones in stock ;)

Sorry to hear that. Front or rear? Upper or lower part? Due to impact/crash?
Send me PM and maybe i can send replacement part.

Yes, sir! Not enough time for playing, but i keep trying. :-)