:thumbsup: Iv heard that one to many times before :p

I never said i was the first to say it :lol::woot:

I know, its still a good joke, dont worry :p

lol... what i meant was it would be nice to have the conversion for the mounts. this way you wont have to make them but if you do make them they are not too hard to make yourself.lol

here is a pic of lewis' car with the servo dropped even further.
http://www.oople.com/rc/photos/nif20...s/OOP_6823.jpg

that's the one I was looking for :thumbsup:

Lewis doesn't do this anymore, he has it set out the same, just isn't low enough to have to cut through the chassis [it just sits on top].

As mattym0310 says you don't have to cut the chassis. Just did it for fun really and to get the servo a fraction lower. Its not hard to do. Bit of masking tape, a dremel and a steady hand. I'll mention the mounting kit to Lewis in the mornig. It souldn't be a problem to organise.

it would certainly help a lot of us out mounting brushless systems :)