Here is a pic of my car with the 0° alu hubs switched L-R.

No problems what so ever :thumbsup:

http://photos.modelmayhem.com/photos...bd4470384d.jpghttp://www.modelmayhem.com/portfolio/pic/25929390Thanks fellas, everyone likes a bit of bling dont they! i noticed that the team drivers all seem to be using the 0 degree hubs but thought with my lack of skill was better of looking flash than trying to be fast lol, anyway since posting i tried the ballstud on the inner two positions and the turnbuckle catches on the aluminium upright to the point where im not convinced its making a good fit, on that basis im thinking if going with the above, any issues?

Will as suggested get hold od some 0 degree as well.

Sorry if its been asked already but whats the kit inboard rear toe in on the C4.1??

Also any ideas on what anti squat to run on carpet??

It's 3 deg inboard toe-in as standard.

MiCk B. :-)

Thanks Mick, am i also right in thinking that the B4 (Not B4.1) rear inner hinge pin block is 3 deg std ??

Yes Mark it is 3-degrees

Cheers Matt :thumbsup: