oOple.com Forums - Slipper shaft not true ?

Page 2 of 2

Show 40 post(s) from this thread on one page

oOple.com Forums (http://www.oople.com/forums/index.php)

- Team Durango (http://www.oople.com/forums/forumdisplay.php?f=80)

- - Slipper shaft not true ? (http://www.oople.com/forums/showthread.php?t=81498)

WHITTLER555

02-10-2011 10:30 AM

Hi, I have sent mine back to Adam for him to check out, I will report back to you and make sure its not builder error!

passy

05-10-2011 03:35 AM

another one not running true here either - shame as I don't have an old one to swap it out with.

WHITTLER555

05-10-2011 03:18 PM

Passy and AndyS - please contact your relative Team Durango importer and speak directly with them, I am sure they will help you out.

MikePimlott

08-10-2011 01:08 PM

Did any body find a cure for this ?

steel

08-10-2011 04:18 PM

yer i would also be interested to find out about this tryed all sorts with mine but still the same

passy

09-10-2011 01:07 AM

For those that have an old version that is true can you work out what part is at fault in the V3 kit?

spring, slipper plate or .....

Many thanks.

Northy

09-10-2011 06:25 AM

If you really think you have a faulty part contact TD

[email protected]

They are a friendly bunch :D

muratti

15-10-2011 08:45 PM

Any news on this topic? Mine runs untrue too:thumbdown:

snook

15-10-2011 10:34 PM

have the 2010 spec car. the slipperplatething is "untrue" since assembly.
i have a spare slipperplatething and i have a spare spurgear.
however i never switched to the spares because it was never a problem.
yes the spur slightly disintegrated after the first 2 runs (there were tiny spurgear flakes all over the inside of the body...)
BUT it still runs just fine, and the mesh was never better.
id just get a spare spur incase anything happens, but would not worry about it.

All times are GMT. The time now is 10:19 PM.

Page 2 of 2

Show 40 post(s) from this thread on one page