try http://www.greenweld.co.uk/acatalog/...inium_185.html
decent prices good lengths for spares

I mean this: Can't you make pins out of the tophalf from a drill, if long enough you can get it in the thicknish you need? There are drills in 2.1mm, 2.2mm etc............
In other words, make new pins from drills:yawn:
(sorry for my broken English)

Thanks for clarifying. Good idea. I did think of that but I didn't want to enlarge the holes on the hub carriers too.

By the way, drill blanks of all sizes are available here...

http://www.drill-service.co.uk/Produ...40000&Tool=363

Done!
 

4D Models were ace... I ordered about 4:00pm and got it the next morning!

http://i103.photobucket.com/albums/m...l/IMG_3903.jpg

http://i103.photobucket.com/albums/m...l/IMG_3905.jpg

http://i103.photobucket.com/albums/m...l/IMG_3910.jpg

Top Fix:thumbsup:

Cheers :)

I think a 2.1mm drill blank might be an even better fit... but it's still much better than it was before.