Shaun i'll bring my laptop tomorrow so you can have a play as you can choose between the HW and SP mod software on that speedo and both have slightly different options!

cheers chris , i can do the software , but just don't which to run ie 528 , 119 ,905 mod etc ...

i was quite happy with the 528stock i was running , until mark said he got told to change it to the mod software !! at least i had a excuse for being slow !!


cheers shaun

Shaun

Base start with mod
3 to 4 on the punch
Turbo about 8 to 12 deg with a 0.004 delay
boost again start at the mid point and tweak to suit
it's like a lot of things down to personel choice

i use speed passion 2.1 pro with stock 422 settings , with a 10.5 motor , works fine for me !

yeah but you know what you are doing with stock settings from years in touring car Glen us meer mortals have to take the simple route!

do you have a kink pls m8.

i can not find anything

I have many kinks but assume you mean link!:o

Go to the bottom of this page.....
http://www.hobbywing.com/product_show.asp?id=218

there are to pdf's you can download then there is a piece of software that you can download that is 3.! version.

i have downloaded the piece and runnning the latest revision of firmware on the esc and the latest version of software on the program card that will work with thte esc. but i still do nto understand the MOD bit. anyway.


on my screen i do nto have turbo does anyone know why that s please??
also there is no diffrence on the screen options if i have the sencor cable connected or not.

cheers
levon

Levon you have got to have it plugged into your computer and then go to advanced option and choose the latest mod software, then do your setup and send to the esc and program box!
Hope this makes sence?

cheers m8.

i did all of that. i just did not get the thing of mod software as that part did not make sence.

but i have now run into a huge problem. the little banana thing that the wire gets soldered onto the motor has come off and lost in the grass. now i know it is nto from over heating as i have telemetry on and the over heat protection on and it did not hit the max temp at all.

so i have now jsut sent a email to obby wing to ask them if they can post a few spares off to me.

Do you know if I can use the £12 hobby wing programmer from giant shark or can I only use the £30 speed passion programmer to programme and do the firmware on the the speed passion lpf speedo?.

I use the hobbywing on my hobbywing and sp esc's with no problems :thumbsup:

yeah thats what i use too , on my sp and hobbywing esc's ..

i'd also just like to say thanks for the help with my speedo settings/software , that i was given , it was alot better on 119mod , soo much smoother :thumbsup: ..