![]() |
Look i'm sorry to all !
I've been in this sport for 30+ years as a child racer, club helper and father ! I've been sat in the tent with a pencil, paper and a stopwatch shouting out car numbers to count racers laps. I welcomed the Handouts Transponders when they came on the scene, thought they were the best thing since sliced bread, gave clubs accurancy to lap counting. I had a small break when Personal Transponders came on the scene but again thought this was a great idea, you could put it where you wanted it, noy drilled into your wing or body shell, body pins flying loose and not counting your laps and you didn't have to cue and remeber to put it on and off to race. I don't want to seem as the bad guy here, nothing could be further from the truth, i'm all for the sport as it is my hobby to after all ! I only post what I see, I have AMB/Mylaps and see that the upgrade is Mylaps looking after my products, customer service is one view, and making sure they count each and every one of my laps, I don't want the opposite for MRT users, have never stated I did. |
In a way it could be a good thing for the smaller clubs as the market will be flooded with 2nd hand digital decodes and pt's
|
Quote:
|
Doh:blush:
|
Its threads like this that is rapidly putting me off this site, along with looking terrible for potential newbies to the hobby/sport.
All this arguing is pointless (much like this post tbh) we can do nothing about this, the clubs will make their decisions and we (if we race at those clubs) have to follow that decision or race elsewhere. I have no doubt a workable solution will come to light, until then you pays your money and takes your choice. You know what they say about arguing on the internet .......... although some on here seem to get off on it / make it a full time job ! :thumbdown: |
no responce to this then?
Quote:
Remind my why you think we need rc4 again? Quote:
|
Quote:
this is a real time live forum and people argue/disagree were not in a nanny state where everyone is wrapped in cotton wool agreeing with everyone. we can do somthing as racer/club members look at york, they have taken a decision and somthing has been done. im sure when i see knighthawk at a meeting we will chat and talk as normal |
Guys guys guys, if I feel I need to be the voice of reason then something must be far out of left feild!!!
I think this will be a non-issue. Most of the clubs will decided that they don't need to change / upgrade so won't so it won't affect 95% of racers. If a national section decides it must go RC4 then they will, the racers dedicated to that section will run the appropriate PT for that section at nationals (and thus probably everywhere else as if they have any sense they will get a Harry as it works on both). Those who aren't prepared to change PT aren't dedicated to that class so will find a different one to race, afterall the majority of racers at national level LIKE to have (not necessarily need to have) the latest greatest kit so change regularly anyway!! The only potential losers, as I see it are MyLaps as nobody in their right mind would currently buy a Percy if they do their research. Even a newbie, a class of club racer that isn't known for forward planning, will almost certainly show up at their first meeting without any transponder. Their prospective club is likely to say "go get a Harry PT for these reasons" and point them to the info on the BBK site. They MIGHT feel the need to add, as I would, "you'll probably be ok with an MRT at this club and MOST around here BUT you might find that you need to change in the future so bare that in mind". There is one issue I can see. If a decoder breaks and has to be repaired and goes back to the club with an unrequested "upgrade" to RC4 that will cause issues for the club. In that situation I would hope that MyLaps would revert the decoder to RC3 for them. With that in mind it might be worth the clubs remembering to specify they want RC3 firmware following any repairs!! |
1 Attachment(s)
Ok, Having read this thread I decided to take a look at my MRT transponder. Attached is the output as seen on a 500Mhz scope. It appears to send data packets of around 100us in length these are not equually spaced and not identical. the fist few bits and last bits of each packet is so I assume this is the lead in and end word, but the middle is different. I will try to decipher the transmission protocol so I can understand it. Anyone else fancy doing the same to a harry?
|
Quote:
Other than that you might as well be speaking Klingon. Infact, if you were I would probably understand more of what you just said! |
Quote:
|
Quote:
I'll probably get one for the pit box as a backup in case I race somewhere that uses the new system, that's 300% better than the 100% correct old system. |
I agree with roger, why is this thred such a bun fight.
the new software will support ALL amb pt's, the only problem is the rc4 is the only software able to recive from a percy so It must be clearly stated on the pack that this is the case so as to stop a new racer, with no knowledge of this buying one only to find he can't use it at many clubs yet. As long as harrys are readily available to buy I see no problem as the rc4 software will receive their signal. You realy can't expect in this day and age a company to happily watch another make money from their product, in this case MRT. AMB want us all to now be buying amb transponders, so they can have the money, as it's all about the money these days is it not? Now if the new system only recived the percy signal, and we were all being forced to buy new percys then I could understand this sort of uproar! Also just for the record, I'm no lover of AMB, I think it's way over priced and if someone like mrt could make something for half the price I would love to see Amb break a sweat.:D |
Quote:
Namely, they'll discontinue "Harry" meaning the new tp is the only one available, to try to force clubs into an rc4 upgrade? I wonder if they have confirmed yet that if your rc3 system goes down they'll repair it without forcing you to go to rc4? |
Quote:
They could stop producing the harry next month, only selling the percy, thus forcing clubs to all upgrade at the same time £££ sweet. |
Slight problem there - That just plays into MRT's hands.
Can't get a Harry but your club is still RC3? You could always buy an MRT. Clubs RC3/2 decoder died and Mylaps want to replace it with an RC4? I'm pretty sure that MRT's guys could repair it whilst still keeping it RC3 spec even if they can't build a duplicate. |
MPG200 - the real interesting thing would be to be able to run that test with an original AMB RC and a MRT clone of it - as clearly there must be some differences.
|
Stormer Hobbies in US are advertising mylaps RC4 transponders which they say are compatable with older amb RC2/RC3 timing systems!!
http://www.stormerhobbies.com/cgi-bi...=ns&pn=MYL1000 |
That's correct, as that's the "RC4 Hybrid", it's the "RC4 Pure" that isn't compatible with older decoders.
|
Quote:
|
All times are GMT. The time now is 06:41 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
oOple.com