the cap' is in there. you can just see the silver part by the sensor plug :)

I ran a 25t pinion on the 7.5 at Kiddy on Sunday in that heat and no problem with the car. shame the servo chewed a gear and the wheel fell off lol

Got there in the end.

http://i15.photobucket.com/albums/a3.../Image0159.jpg

Done a bit of rewiring, cut the switch off and shortened the capacitor wires, servo/esc/pt wires will get shortened at some point

http://img502.imageshack.us/img502/9671/img0467o.jpg

my v3. just rewired and new motor fitted.

Nice neat job Bryan, but you need an aerial tube for that receiver aerial.:thumbsup:

thanks raymond. i was thinking about an aerial tube but it would only stick up about an inch. might just leave the wire under the shell. when i get my shell on sunday from mg paint

i love this thread! :thumbsup:

i am in the process of building a 410R and installing the electrics. i am running a speed passion 2.0 GT and stock 13.5t V3 motor. i am yet to buy my RX/TX and many people have mentioned a micro receiver for ease of install, are these normal? which RX come with micro receivers?



Thanks

Here's my effort. Snug.

http://img585.imageshack.us/img585/8423/photovij.jpg

410
 

My install

http://img838.imageshack.us/img838/5...1702568327.jpg

Don't think many actually come paired with the micro receivers, but i use spektrum, which has a micro receiver available. Might be worth seeing if the new 2 channel spektrum is compatible with the micro Rx (i suspect it is). As that looks very good for the money!

KO Universe 3 comes with a micro RX :thumbsup:

Attachment 35485

Attachment 35486

tight squeeze! Not much room at all

Looks nice, any chance of a close up shot?

samd :lol:

My 410
 

http://img832.imageshack.us/img832/3...2190198308.jpg
:lol:

you could cut crimp the servo wires. will free up a bit of space :drool:

Just out of curiosity what do people use to crimp servo wires to the servo conectors?

you can find them on ebay but otherwise this place below is pretty reputable:

http://www.hansenhobbies.com/products/connectors/tools/

i've got the Economy crimping tool and it meets all my requirements.

My new setup. Epic Trinity revtech 6.5, Speedpassion Esc and Sanwa RX.

Here is my first ever install, this thread was very helpful!!:thumbsup: